Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Kirtland, NM

CHI Overhead Doors Garage Door Cable Repair in Kirtland, NM

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

From the first phone call to the final safety test, CHI Overhead Doors garage door cable repair in Kirtland, NM follows a simple process: diagnose, quote, repair, test. Frayed, snapped or slipped lift cables replaced and the door re-leveled. We work on CHI Overhead Doors garage doors of every age, from older models to current lines, and carry or can source compatible parts. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for CHI Overhead Doors garage door cable repair

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

Common causes

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

Before the technician arrives

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

How much does CHI Overhead Doors garage door cable repair cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

Local CHI Overhead Doors garage door cable repair for Kirtland, NM

Fine dust in New Mexico packs into roller bearings and the track, so rollers start to drag and squeal well before they are worn out.

Technicians serve all of Kirtland (ZIP code 87417), plus Farmington (7.8 mi), Flora Vista (16 mi), West Hammond (17.6 mi) and Shiprock (18.5 mi). Call (833) 435-8883 to book a visit in Kirtland.

CHI Overhead Doors Garage Door Cable Repair: frequently asked questions

How much does CHI Overhead Doors garage door cable repair cost in Kirtland, NM?

CHI Overhead Doors Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Mexico or Kirtland requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Kirtland, NM

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Allstar Opener Circuit Board Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $175-$400

Hörmann Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Midland Garage Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Garaga Garage Door Track Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$400

CHI Overhead Doors Off-Track Garage Door Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $175-$450

Sommer Opener Gear & Sprocket Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$275

Raynor Weather Seal Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $100-$300

Overhead Door Opener Gear & Sprocket Replacement

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $125-$275

Ideal Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Allstar Garage Door Sensor Repair

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $100-$250

Martin Door Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Kirtland, NM now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote